Replacement Gas Cap Tether for Nissan Frontier
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A replacement gas cap tether for the OEM gas cap on a 2014 Nissan Frontier.
- Ocena
- 5 / 5
- Polubienia
- 44
- Pobrania
- 213
- Wydruki
- 1
- Wyświetlenia
- 1132
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
There's a few gas cap tethers on here already, but none of them fit my 2014 Nissan Frontier. So I modeled up one compatible with that vehicle.
I'd lost the original plastic peg that held the tether to the door so I designed this one to be press-fit into place. Fit and retention force seems good. However, I did include a STEP file if anyone wants to change the press-fit back to the original ring design.
This should be printed in a TPU or a similar flex material. I have not tested, nor do I suspect it will work well, in a rigid filament.
Compatibility:
As mentioned this is for the OEM gas cap on a 2014 Nissan Frontier. If you suspect it might be compatible with your vehicle based on general appearance I'd check these two measurements:
- Inner diameter of the gas cap ring = 60mm
- Diameter of the hole on the door = 4.75mm
Here are the print settings I had success with:
- 0.2mm layer height with a 0.4mm nozzle
- 4 bottom layers, 5 top layers, 4 perimeters
- 15% infill
This does not need any supports.