1 / 2
Magnetic whiteboard marker holder — zdjęcie 1
1 / 2

Magnetic whiteboard marker holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Magnetic whiteboard marker holder for 5/8/10 markers

Ocena
5 / 5
Polubienia
12
Pobrania
167
Wydruki
3
Wyświetlenia
736
Oceny
3

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Office
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Marker holder with magnets!
Uses 20x6x2mm magnets.
Variants for 5, 8 or 10 markers.
25mm holes fit all marker types I have ever come across.
5 and 8 variants fit on MK3. For the 10 marker variant, you will need something slightly bigger. Or just print more than one!

Print instructions:
There are 2 rows of magnets inside. The magnets are fully enclosed. You will need to stop your printer at 22.5mm and 60mm Z-height to add the magnets. In total, there are 8/14/18 magnet holes depending on model. You don't have to fill all of them, but for best holding ability, you should. It will still hold on vertical whiteboard, if you only fill half of them, but barely.

If there is any magnetic part near your hotend(such as the MBL probe on MK3 and MINI), take care to orient your magnets properly. The bottom row of magnets will happily stick to the steel sheet of your printer. Hovewer, the top row has to be attracted to the bottom row. If it's not, the magnets will jump out when your extruder passes by. Don't ask me how I know 🤬

This model doesn't require supports, or any post-processing.

Tagi