Drive shaft for Bosch MUM Multimixer attachment
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement part for the new Multimixer attachment
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 462
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- GNU General Public License v3.0
Had a broken drive shaft for the Bosh MUM (series 8 i believe) Multimixer, so I modeled a new one.
I suggest printing it as is which uses the least amount of supports but printing in upside down might also be a good idea although you'll need more supports. I printed it on my Prusa MKS3+ with PLA and 0.3mm layer height, which turned out fine, but PETG might be a better idea.
This is quite a complex part (at least with my limited experience with 3D modeling) and since I haven't extensively tested it any feedback is appreciated. This is also my first published 3D model so any tips and constructed criticism is more than welcome.