VKB STECS / MCG-U TDC Hat Button Cap Pack v1.1
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Collection of TDC/ministick hat button caps for the VKB STECS throttle and MCG-U joystick. See README for instructions.
- Ocena
- 5 / 5
- Polubienia
- 57
- Pobrania
- 791
- Wydruki
- 3
- Wyświetlenia
- 3498
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
VKB STECS / MCG-U TDC Hat Button Cap Pack v1.1
Created by John5
CC BY-NC-SA 4.0
Special thanks to an anonymous member of the VKB Discord for help with measurements of the OEM VKB MCG-U hats.
Note: Failure to follow instructions for FDM printing will likely result in being unable to install the hat button cap.
*********************************************
INSTRUCTIONS FOR FDM 3D PRINTING:
1. Print oriented 'stem' down, with the tactile area facing upwards.
2. Create support 10x10 cylindrical support blocker centered about the center axis.
3. Add support on build plate only.
4. Print with brim >4mm.
5. Print with maximum 0.16mm layer height (0.12 recommended).
6. Print with >4 perimeter walls.
7. Print with 100% infill.
8. If using PrusaSlicer, use "Arachne" perimeter generator.
9. Use caution when removing support material to avoid damaging spherical 'skirt'.
*********************************************
Changelog:
v1.1 - Increased fillet size on short edge dome for thumb comfort. Added 90 degree variants.