EVA 3 PCB Klicky Probe Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A PCB Klicky probe for An EVA 3 / EVA 3.1 / Rat Rig V-Core 3.1
- Ocena
- 5 / 5
- Polubienia
- 45
- Pobrania
- 301
- Wydruki
- 1
- Wyświetlenia
- 2078
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is an EVA3 or EVA 3.1 probe mount for the PCB Klicky rev3 probe.
It's based on the probe mount for Volcano hotends by Matthew Johnson but shortened so that the probe offset isn't too high. The problem with using the Volcano mount on a non-Volcano setup is that the probe will sometimes drag on the bed while traveling when deployed.
Use it with Matthew's adjustable klicky probe dock as the docking height isn't the same as the official V-Core 3.1 klicky probe. I also recommend his probe dock mount for V-Core 3.1 that works with the Enclosure 2.0.
Required Hardware
All the hardware you need is in your probe kit. No additional hardware is required.
Assembly
Insert the M2 D3.2 L4.0 heat-set inserts from the bottom.
Printing
Print the model in the original orientation. All STLs are pre-rotated for printing.
- Material: ASA, ABS, PETG
- Extrusion width: 0.4 or 0.45
- Layer height: 0.2mm
- Perimeters: 4
- Infill: 30-40%
- Top / bottom solid layers: 4-5
- Supports: No