2x4 Basics Shelf Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is my early attempt to replicate the "2x4 Basics Shelflink" system
- Ocena
- 0 / 5
- Polubienia
- 20
- Pobrania
- 185
- Wydruki
- 0
- Wyświetlenia
- 1496
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The motivation for this project was just to prove to myself that it could be done. I haven't seen any other models of this online. I'm not really a fan of the “just buy them” argument if I have the means and knowledge to make it myself and do it cheaper.
GOAL #1: To make a 3D printable model of the “2x4 Basics Shelflink” system that allows you to create shelves, benches, tool carts, etc. out of 2x4 lumber.
GOAL #2: To make the 3D printed version match the strength of the original product as closely as possible.
- Will need to support static loads of ~50-150lbs (arbitrary) when used in pairs.
- Resistant to shear and torsion
GOAL #3: To make the cost of printing equivalent to the original product ($6/unit)
GOAL #4: Modify design to further decrease printing cost without sacrificing strength.
I've managed to cross off goal #1 and goal #3 (based on cost calculation post-slicing with PLA/+ at $15-20/spool)
I have yet to print this model as it is too large to print in one piece in the strongest orientation on my Neptune 3 Plus. Until I get a larger printer, I intend to work on a split model that will not sacrifice strength or cost.