1 / 3
Plain Nozzle Box (print-in-place, for 25 MK8/V6/Volcano Nozzles) — zdjęcie 1
1 / 3

Plain Nozzle Box (print-in-place, for 25 MK8/V6/Volcano Nozzles)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A nozzle box that fits 25 MK8, V6 and Volcano nozzles. Prints in place. Remains closed with magnets.

Ocena
4 / 5
Polubienia
14
Pobrania
144
Wydruki
4
Wyświetlenia
691
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a remix of the original nozzlebox with options that fit Volcano and MK8 nozzles. Like the original, it prints in place and is locked by a magnet (6x2mm!) and an M3x6 (or smaller) screw. 
It doesn't come with any markings so that one can just add a sheet of paper (of which I attached a paper with the exact dimensions for a print-out)

The contraption is printed at an angle so that even dirty nozzles should fit – the bottom of the contraption is 7mm apart while the top is 6mm or 5,8mm.

Thank you very much @dodasch and @reemo for the original model and the description. 

If you want to change anything, feel free to use the Oneshape Documents

The box parameters can be changed easily, the tolerances and angles will probably be a bit  trickier. 

Printing

  • 0.2mm layer height
  • Well tuned flow (maybe lessen the outer-wall flow) so the hinge and the ball print properly
  • I used the 

Assembly

  • Press the 6x2mm magnets into the holes on the bottom part (i used a bit of superglue)
  • Screw the M3x6mm countersunk screws into the base of the top part

Warning

  • I didn't print the standard version, but reduced the height of the contraption and the box compared to the volcano box.
  • I didn't have 5x2mm magnets, so this version uses 6x2mm magnets. I can provide a 5x2mm version if there's demand for that.

Other Versions

Important:

  • Make sure you post a make so I can see I'm not wasting my time xD
  • If you have any questions, ideas, concerns and objections please let me know.
  • I will ad testprints in a few days or weeks so you dont have to Print the whole box to test it out which top diameter you need. I recomend the 5,8mm

Tagi