Flipper Zero - Wi-Fi Dev Board Case (Basic)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A basic case for the Flipper Zero Wi-Fi Dev Board - remix.
- Ocena
- 0 / 5
- Polubienia
- 24
- Pobrania
- 253
- Wydruki
- 1
- Wyświetlenia
- 1539
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial
This print is specifically designed for the basic WiFi board straight out of the box, omitting features such as the antenna and SD card slot.
This creation is a remix of magdong's Wi-Fi Dev Board Case (https://www.thingiverse.com/thing:5564906).
For secure assembly, utilize 4 x M3x12mm screws accompanied by 4 x M3 nuts.
This design also has a pin protector boot cover that can be found in the following locations:
- https://www.printables.com/model/606861
- https://www.thingiverse.com/thing:6104552
- https://github.com/CodyTolene/3D-Printing/tree/main/Flipper%20Zero%20-%20WiFi%20Dev%20Board%20Case%20Boot%20Cover
My print settings:
- Hatchbox PLA
- 0.2mm layer height
- 0.4mm nozzle (line width)
- Enable retraction
- Wall count 3 (+ print thin walls enabled)
- Top/bottom layers: 4
- Infill density: 20%
- Infill pattern: Cubic
- Print temp 200 C
- Bed temp 60 C
- No supports needed
See more designs on my GitHub here: https://github.com/CodyTolene/3D-Printing