Push-in Opel Meriva shelf pin
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Push-in pin for holding back shelf in opel meriva version b
- Ocena
- 4 / 5
- Polubienia
- 19
- Pobrania
- 93
- Wydruki
- 1
- Wyświetlenia
- 752
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Public Domain
Story/Design:
Pins that were holding the back shelf of the meriva got broken, so I designed them to be push-in pins, because it was hard to get to the other side of the plastic. I also wanted it to be locked in place as people who are using this car are popping the shelf with quite a bit of force.
Unfortunately, when I came to take some measurements of the pin hole there was no original pin left, since I don't know how it looks, I'm not gonna compare them side by side.
Instructions:
To lock the pin in place Im using some weak zip-tie. I use a weak one because it snaps after locking in place so there is no zip-tie left behind the plastic wall. However, if you print it with PLA, zip-tie might snap before locking, and you will be left without a locking piece (happened to me once)!
Printing:
Since you need to squish it a little before inserting, and then it needs to expand when in its place, I strongly suggest printing it with PETG or something similarly flexible. I printed it horizontally and got good results.