1 / 8
Magnetic Tiles Haunted House: Railings, Pillars, Arches & Beams — zdjęcie 1
1 / 8

Magnetic Tiles Haunted House: Railings, Pillars, Arches & Beams

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Here are the railing, pillar, arch and beam pieces for the magnetic tile haunted house.

Ocena
0 / 5
Polubienia
51
Pobrania
143
Wydruki
0
Wyświetlenia
684
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Engineering
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

Here are the railing, pillar, arch and beam pieces for the magnetic tile haunted house. 

General information for all these pieces:

PLA Filament

Layer height 0.2mm

Infill 15-20%

No supports needed (see recommendations for brims below)

Neodymium magnets needed for arches and railings: 20x5x2 and 10x5x2.

Neodymium magnet size need for pillars: 12x5x3 OR 10x5x2

Magnetic build plate highly recommended but not absolutely necessary.

Arches

Neodymium magnets sizes needed for the arches: 20x5x2 and 10x5x2 (I strongly recommend using these size magnets. If you go larger it may not allow the magnets to rotate within their chambers.)

I recommend brims for the arches to prevent warping at edges.

For the arches, add a pause print at layer height 6.0mm to insert the magnets. When the print is paused insert the magnets.  I like to alternate these two size magnets between the magnets holes (20x5x2, 10x5x2,20x5x2, 10x5x2, etc.).  I found if I used all 20x5x2 they were too strong and if I used all 10x5x2 it felt a little too weak.

After the magnets are inserted, resume the print.

Railings

Neodymium magnet size need for railings: 20x5x2 and 10x5x2

Brims are not needed for the railings.

Add a pause print at layer height 6.2mm to insert the magnets.  I like 20x5x2 for the magnets at the bottom of the railing and 10x5x2 for the magnets along the side of left and right railings. Insert magnets, then resume print.

Pillars

I recommend a brim for the pillar body/base piece because it is tall.  The brim will help add stability. 

Add a pause print at layer height 6.0 mm to insert the magnets. Insert magnets, then resume print. That's it:)

Here is a link to Amazon for the magnets needed for this print:

https://www.amazon.com/shop/3dpmom

Tagi