Magnetic Tiles Haunted House: Railings, Pillars, Arches & Beams
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Here are the railing, pillar, arch and beam pieces for the magnetic tile haunted house.
- Rating
- 0 / 5
- Likes
- 51
- Downloads
- 143
- Makes
- 0
- Views
- 684
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Engineering
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Here are the railing, pillar, arch and beam pieces for the magnetic tile haunted house.
General information for all these pieces:
PLA Filament
Layer height 0.2mm
Infill 15-20%
No supports needed (see recommendations for brims below)
Neodymium magnets needed for arches and railings: 20x5x2 and 10x5x2.
Neodymium magnet size need for pillars: 12x5x3 OR 10x5x2
Magnetic build plate highly recommended but not absolutely necessary.
Arches
Neodymium magnets sizes needed for the arches: 20x5x2 and 10x5x2 (I strongly recommend using these size magnets. If you go larger it may not allow the magnets to rotate within their chambers.)
I recommend brims for the arches to prevent warping at edges.
For the arches, add a pause print at layer height 6.0mm to insert the magnets. When the print is paused insert the magnets. I like to alternate these two size magnets between the magnets holes (20x5x2, 10x5x2,20x5x2, 10x5x2, etc.). I found if I used all 20x5x2 they were too strong and if I used all 10x5x2 it felt a little too weak.
After the magnets are inserted, resume the print.
Railings
Neodymium magnet size need for railings: 20x5x2 and 10x5x2
Brims are not needed for the railings.
Add a pause print at layer height 6.2mm to insert the magnets. I like 20x5x2 for the magnets at the bottom of the railing and 10x5x2 for the magnets along the side of left and right railings. Insert magnets, then resume print.
Pillars
I recommend a brim for the pillar body/base piece because it is tall. The brim will help add stability.
Add a pause print at layer height 6.0 mm to insert the magnets. Insert magnets, then resume print. That's it:)
Here is a link to Amazon for the magnets needed for this print: