Xiaomi M365/M365 Pro/1S/Pro 2 Electric Scooter Back Mudguard
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Rear fender and mudguard compatible with Xiaomi M365 variants and clones.
- Ocena
- 0 / 5
- Polubienia
- 73
- Pobrania
- 583
- Wydruki
- 0
- Wyświetlenia
- 4633
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution
I got an old scooter from a friend, but the rear mudguard was broken off and missing. I designed this to be as close to the original as possible while still being easy to print.
-----Slicing-----
- Because this model is too large to fit on most 3d printers, I suggest cutting it in Prusaslicer. I have had success with the following settings:
Mode: Dovetail
Depth: 40mm
Width: 20mm
Width Tolerance: 0.5mm (some sanding may still be necessary)
Flap Angle: 90

- Make sure that the wire brackets underneath are pointing upwards.

- Supports are necessary. I've had issues with supports when using input shaping speeds, so be aware of what your printer can handle.
- Adding color changes is a really easy way to spice up your print, and it looks amazing on this model.
-----Assembly Instructions-----
1. Run the wire through the rectangle in the back and install the mounting screws.

2. Slide the wire behind the mounting brackets. It should be a fairly tight fit.

3. After plugging the light in, mount the mudguard using the three bolt holes in the front.
