Xiaomi M365/M365 Pro/1S/Pro 2 Electric Scooter Back Mudguard
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Rear fender and mudguard compatible with Xiaomi M365 variants and clones.
- Rating
- 0 / 5
- Likes
- 73
- Downloads
- 583
- Makes
- 0
- Views
- 4,641
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution
I got an old scooter from a friend, but the rear mudguard was broken off and missing. I designed this to be as close to the original as possible while still being easy to print.
-----Slicing-----
- Because this model is too large to fit on most 3d printers, I suggest cutting it in Prusaslicer. I have had success with the following settings:
Mode: Dovetail
Depth: 40mm
Width: 20mm
Width Tolerance: 0.5mm (some sanding may still be necessary)
Flap Angle: 90

- Make sure that the wire brackets underneath are pointing upwards.

- Supports are necessary. I've had issues with supports when using input shaping speeds, so be aware of what your printer can handle.
- Adding color changes is a really easy way to spice up your print, and it looks amazing on this model.
-----Assembly Instructions-----
1. Run the wire through the rectangle in the back and install the mounting screws.

2. Slide the wire behind the mounting brackets. It should be a fairly tight fit.

3. After plugging the light in, mount the mudguard using the three bolt holes in the front.
