IKEA JANSJÖ Lamp LED clamp spotlight - complete Clip / Klemme

The otherwise very practical IKEA lamp, for clipping onto a shelf, has unfortunately broken. Both parts of the clamp broke after only a few years and the whole lamp could no longer be used. In FreeCAD I designed a replacement part for it, which corresponds to the original, but is stronger at the points where the highest forces act.

Compatibility

• Compatible with IKEA JANSJO lamp type V1431 (old design).
• The clamp is not compatible with the new LED clamp spotlight model from Ikea called NÄVLINGE. The tip of the anti-slip rubber pads on the new model are round instead of square.

Features

• Complete Clamp (2 Parts).
• Increased material thickness in the area where the old clip was broken.
• The original rubber pads can be reused.

Update of 12 July 2024

MainBody-V3 changes:

• increased M6 cable clamping thread
• additional M8 lamp stem thread
  
  

Print recommendations

• Material: PETG
• Nozzle diameter: 0.4 mm
• Layer height: 0.20 mm
• Perimeter: 4
• Infill: 100%

Assembly

Insert the original rubber pads on both sides.

Screw the lamp stem into the intended M8 thread. A tip if the M8 thread is too narrow, you could widen it a little with an M8 screw or a thread tap.

Solder the cable and then insulate the soldered connections with heat-shrink tubing.

Use the original M6 grub screw to fix the cable in the strain relief. You've done it, that's it.

For the rotation axis I use a M3 x 40 mm flat head screw, which is 3 mm too long.
I shortened the screw by 3 mm.
To secure the screw I used a self-locking M3 nut.

My clip is working great for 2 years now.
Have fun fixing your Ikea lamp.

Updates