BetaFPV Pavo Pico battery plate
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Battery plate to add anti-slip pad for battery
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 153
- Wydruki
- 0
- Wyświetlenia
- 1847
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The BetaFPV Pavo Pico has a battery holder than can only hold a very specific size and like everyone, I don't have them.
The usual way to deal with it is to snip off the holder legs and use a strap. The issue is that, in my case, the battery could slip from it no matter how tight I strap the battery.
This little piece of plastic add a flat base where you can put a sticky pad or rubber to grab onto the batterie.
- Cut the legs flush and remove every bit of plastic until the base is flat.
- Print in heat resistant plastic, the CPU is right above that part and can get toasty!
Add 0.60gr + your pad (mine is from TBS “Battery Anti-slip Pad” which total 1.65gr more).
Pad size standard version: 16x20mm.
Pad size reversed version: 20x20mm
---
NOTE: There's two version: standard or reversed. The one on the picture is the standard which is glued from INSIDE the duct but after several flight/crash mine broke the original plastic bridging so the reversed version is made to be glued from the OUTSIDE.
In case of a hard landing or crash, the impact will be spread across a wider area instead of the small plastic bridge since the reversed version as small lips that rest along the side.