1 / 3
BetaFPV Pavo Pico battery plate — image 1
1 / 3

BetaFPV Pavo Pico battery plate

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Battery plate to add anti-slip pad for battery

Rating
0 / 5
Likes
17
Downloads
153
Makes
0
Views
1,847
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

The BetaFPV Pavo Pico has a battery holder than can only hold a very specific size and like everyone, I don't have them.

The usual way to deal with it is to snip off the holder legs and use a strap. The issue is that, in my case, the battery could slip from it no matter how tight I strap the battery.

This little piece of plastic add a flat base where you can put a sticky pad or rubber to grab onto the batterie.

  • Cut the legs flush and remove every bit of plastic until the base is flat.
  • Print in heat resistant plastic, the CPU is right above that part and can get toasty!

Add 0.60gr + your pad (mine is from TBS “Battery Anti-slip Pad” which total 1.65gr more).

Pad size standard version: 16x20mm.

Pad size reversed version: 20x20mm

 

---

NOTE: There's two version: standard or reversed. The one on the picture is the standard which is glued from INSIDE the duct but after several flight/crash mine broke the original plastic bridging so the reversed version is made to be glued from the OUTSIDE.

In case of a hard landing or crash, the impact will be spread across a wider area instead of the small plastic bridge since the reversed version as small lips that rest along the side.

Tags