1 / 1
Magnetic holder for an Espresso WDT Tool (2x 10mm magnets) — zdjęcie 1

Magnetic holder for an Espresso WDT Tool (2x 10mm magnets)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Simple holder for a reasonably cheap but neat wooden WDT tool off Amazon. Requires two 10mm x 2mm magnets.

Ocena
0 / 5
Polubienia
6
Pobrania
39
Wydruki
0
Wyświetlenia
428
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Noncommercial

Inspired by some other models which were made for other WDTs, and unable to find anything that would accommodate my 10mm x 2mm magnets, I designed my own from scratch. It fits a relatively cheap (but nice) wooden-looking WDT from NEOUZA (sold on Amazon) perfectly and holds stable on a Breville espresso machine. It's also a bit more “rounded” for a neater (imo) look than the others available.

Magnets have a bit of tolerance leeway and you can just super-glue them inside their slots.

No supports needed, took around 15 minutes on an Ender 3. Print with the largest flat side down (should be obvious once you load the model file).

There's a little bit of extra (0.2 - 0.5mm) space between magnets and the machine so that they don't directly touch the machine (i.e. once mounted, this print will should not scratch the machine if moved around - a bit of sanding might be good to even the surface that touches the machine)

 

The holder grips 7mm of the WDT Tool. 

Bottom radius is 9.5mm and top radius is 10.25mm (19mm and 20.5mm diameter respectively) in case you want to measure yours to see if will fit.

Tagi