IKEA Malm trash bin
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This small trash bin hangs on the MALMs drawer. Everything is printed flat without supports and slide into place-No Glue
- Ocena
- 5 / 5
- Polubienia
- 53
- Pobrania
- 145
- Wydruki
- 2
- Wyświetlenia
- 1322
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
Print out two sides, two fronts and a bottom. Use draft mode with 5% infill.
Insert the bottom plate into the sides and then slide the fronts onto the side. Now you can hang your finished trash bin onto the drawer of your choise.
The drawer will close completely even with the trash bin as it has a 3mm gap per defalt and this model is using this space.
I use mine for the little filament bits, it's an aford to control them. I previously had them everywhere….
As always, comment and post makes, it would make my day :)