Springy Doorstop (flexible and in multiple sizes!)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Alternative to the traditional doorstop - using the flexibility from the plastic to adjust to the door. Easy to print!
- Ocena
- 4,693 / 5
- Polubienia
- 3582
- Pobrania
- 14 922
- Wydruki
- 196
- Wyświetlenia
- 40 922
- Oceny
- 153
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
| Welcome to GlennovitS3D. Join the Club on Printables.com to support creation of new models, get access to exclusive models, and get commercial rights, to sell prints. Join today - GlennovitS3D - or check out my model collection or my popular models |
Updates
9. Nov 2023 - Added multiple new versions. Both with higher and lower angle (to fit more doors) AND all versions with a normal and a pointy version (where the tip is not rounded, to fit under doors with less space below)
Description
Want a minimalistic doorstop, that is easy to print and uses the material flexibility to lock the door in place - then look no further!
Overview
This doorstop comes in multiple sizes, and can be scaled to your liking. So give it a go, try it out, and if you want, print another one that is smaller/bigger, stronger or more flexible - to be the perfect fit for your door!
Sizes
The model comes in 24 versions now.
It comes in 4 sizes:
- Small
- Medium
- Large
- X-Large
There are also 3 angles to fit different space below different doors:
- Low angle
- Default
- High angle
And there are 2 styles of the tip
- Default (rounded at the tip)
- Pointy (to fit under very tight spaces)
All of the versions are 40 mm in width as standard, but can be scaled up and down in the slicer (just scale the Z direction)
| More practical prints? I got you covered! Check out this collection of practical models - everything from tools to storage solutions. |
Print instructions
- Speed on first layer: 50% (To ensure good bed adhesion)
- Infill: 0% (to make the model 'springy’)
- Top/bottom layers: 0
- Perimeters: 2-3 (try out different combinations - the ‘springyness’ is very depending on this parameter AND the material of your choice!)
You can also to a stylised version with exposed infill if you like that look. Makes the model less flexible, but more stylised - your choice.
- Infill: 5-15%
- Infill pattern: Honeycomb (or gyroid or whatever you like the best!)
Happy printing!