FairPhone 4 holder for cars
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holder 4 FP4, I reused the gooseneck of an old holder so that part is missing and will have to be adapted by you somehow
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 51
- Wydruki
- 0
- Wyświetlenia
- 449
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a Holder for a Fairphone 4. I designed it to replace a holder I already had in my car that was too small for the fairphone, so there were parts, that I already had installed and reused. (Ball-joint and gooseneck) I included a stub balljoint with a throat of of 5mm that has a 2.5mm bore so you can screw a m3 bolt in there.
The fit of the holder works great with my own bumper case, but I had a bigger one on there before and that still fit.
The female part of the balljoint is fixed to the holder with 4 countersunk 10mm M3 screws.
printing:
If you want to use it in a car, use heat resistant filament with good layer adhesion. PETG might work, I used PCTG and it works great. Parts with threads @0.1 layer height, the rest@ 0.2mm. Annealed PLA might also work. Give it plenty of printing temp for better layer adhesion, especially the balljoint parts need it.
Category: Mobile Phone