1 / 1
Desiccant drier cage for use with filament driers
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a reengineering of the a desiccant drier by Kyaenos on another site.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 59
- Wydruki
- 0
- Wyświetlenia
- 493
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
SzczegółyPliki (5)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (15)Powiązane
This is a re-engineering of a desiccant drier I saw on another site. I created this model in Fusion 360
- The original model screwed at the centre, allowing the edges to flex and leak desiccant. I added threads to the outside cover edge for a secure seal
- Added inner lip to the cover to secure the inside perimeter
- Created a fill and drain port
- Created a funnel and spout that can be screwed into the port for hands and mess free transfers
I am not convinced this is a worthwhile endeavour, microwaves are much faster. Let me know what you think.
- Makes sure you print in ABS for heat resistance. PETG ones can and have melted
- Use a .28 layer height for the main body and expect a 10 hour print on a Bambu X1CC in regular mode
- All other parts need to be printed at 2.0 for threads to work.
- Heat soak your printer with bed set to 100 degrees for at least an hour if printing on a Bambu X1CC
- It may be tough to screw the top cover in so just push it in and it will ‘clip’ in. Then you ran rotate the cover to tighten