Makita DJV182 dust nozzle (126331-0) adapter for Dyson DC19
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is adapter to connect Dyson DC19 to Makita Jigsaws that are compatible with 126331-0 dust nozzle.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 38
- Wydruki
- 0
- Wyświetlenia
- 449
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Dust collection does wonders. When i used jigsaw for the first time the problem was that dust from cutting would obscure view on cutting blade and made guiding tool difficult.
To prevent that from happening i decided to make an adapter to connect my vacuum cleaner to the tool and here it is, dust nozzle adapter for Dyson DC19 and Makita DJV182 or any other ciruclar saw that uses 126331-0 dust nozzle part.
In order to attach it you need to take off hard pipe off the vacuum cleaner tube and remove plastic handle to which pipe is connected. Once you end up with loose end of the pipe you plug it into bigger adapter hole and into smaller hole goes the dust nozzle.
Its a little bit of tight fit on the dust nozzle side but that's good, you don't want your hose to break free while operating on cutting machinery.
Recommended print settings:
- layer height: 0.1mm or adaptive (0.1mm around curves and 0.2mm on straight parts)
- supports: yes, everywhere, see below for print orientation to minimize supports
- print orientation: place it with smaller end on the print plate, to do so right after importing part to slicer rotate it by 180 + 22.5 degrees (see screenshot from Prusa Slicer)