Wireless Headphone Case SteelSeries Nova 7 and more
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Carrying case for SteelSeries Wireless Headphones Nova 7 and more.
- Ocena
- 4 / 5
- Polubienia
- 51
- Pobrania
- 247
- Wydruki
- 2
- Wyświetlenia
- 1939
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution — Noncommercial
Intro:
This is a travel case I have designed for traveling. It's fits the Nova 7, and I assume the 7X and 7P. There's a smaller compartment to fit the wireless receiver and a small charging cable.
Print settings:
I printed this all in PLA with 0.2mm height. I haven't tested any other filaments.
Supports:
You could go support free with this. I used small supports to print the inside of the hinges but it's mostly designed to be support free.
Sizes:
The inside is 200mm wide at the speakers, 165mm widest at the headband and 200mm tall.
Hardware:
The hinge takes two M3 x 25mm screws and the magnets are 3x6mm. The 2 screws install from either side of the hinge to meet in the middle.
Notes:
This prints in two pieces with both having the outside facing down on the print surface.