Wireless Headphone Case SteelSeries Nova 7 and more
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Carrying case for SteelSeries Wireless Headphones Nova 7 and more.
- Rating
- 4 / 5
- Likes
- 51
- Downloads
- 247
- Makes
- 2
- Views
- 1,939
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Music
- License
- Creative Commons — Attribution — Noncommercial
Intro:
This is a travel case I have designed for traveling. It's fits the Nova 7, and I assume the 7X and 7P. There's a smaller compartment to fit the wireless receiver and a small charging cable.
Print settings:
I printed this all in PLA with 0.2mm height. I haven't tested any other filaments.
Supports:
You could go support free with this. I used small supports to print the inside of the hinges but it's mostly designed to be support free.
Sizes:
The inside is 200mm wide at the speakers, 165mm widest at the headband and 200mm tall.
Hardware:
The hinge takes two M3 x 25mm screws and the magnets are 3x6mm. The 2 screws install from either side of the hinge to meet in the middle.
Notes:
This prints in two pieces with both having the outside facing down on the print surface.