ESP32_Cam mount for Prusa enXLosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
mount to add a ESP32 camera to the inside of the prusa enXLosure
- Ocena
- 4,333 / 5
- Polubienia
- 46
- Pobrania
- 202
- Wydruki
- 4
- Wyświetlenia
- 1687
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted a camera inside my prusa enXLosure to connect to prusalink/ -connect.
For this upgrade you will need;
- ESP32-CAM module
- 1x M3 Heatset insert
- 1x M3x8 bolt
- Micro-USB cable (best to get right-angle)
- USB powerbrick
- You will need to print the "EnXLosure_Bottom_BR_cableguide" version or drill a hole in the corner of the part to route the power cable thru the frame
Installation;
Step 1; insert the M3 heatset insert to the first heatset hole on the inside of frontright corner.
Step 2; Place the ESP32-CAM module in the 3D printed housing. (base)
Step 3; Install the front cover of the ESP32-CAM module.
Step 4; Instal the assembled module in the front right corner of the prusa enXLosure.
Step 5; Insert te micro-USB and route it thru the side and out of the rear of the enXLosure.
Software;
For installation of the camera software, please follow the setup found here
config for software;
Please turn on both "Hmirror" and "Vflip" to get correct orientation