SSD Mounting Ears - 2.5" SATA
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount an SSD with an RPi together, with a bit of air-flow around them.
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 34
- Wydruki
- 1
- Wyświetlenia
- 403
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
Adding an SSD to an Raspberry Pi, I wanted to have the two units together, with a bit of air-flow around them. Or use the ‘ears’ to just mount your SSD solidly on its own.
These 'ears' will align, for example, with the RPi case from @plammers on here. For me this is an RPi4B, but other cases should align with the same (75 x 75mm) mounting holes as well, though I haven't checked any for suitable alignment.
Note: mount the clamp ears to the drive first – if you were to use it without attaching to the ears to the SSD you'd risk the drive falling out, which you don't want.
Pics show the alignment, and a little floor-stand I use for working on the RPi + SSD when I need it nearby during development (this is a HomeAssistant installation).
Orient the ears on your print bed in an upwards “U” orientation so that you don't need any supports.
Design Date: Oct 2023