Sock Clip for Drying Rack
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Practical holder for socks and small items that can be attached to a drying rack.
- Ocena
- 4,75 / 5
- Polubienia
- 52
- Pobrania
- 167
- Wydruki
- 4
- Wyświetlenia
- 982
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Details
Practical holder for socks and small items that can be attached to a drying rack. This makes hanging and unhanging a breeze, especially the unhanging part, as you can just pull each sock/item off like ripe fruit. No need to remove a clothespin for every single sock on your drying rack.
To attach it to your drying rack, just use zip ties that go through the holes on the top of the model.
I planned to make a ziptie-less version, but that adds a lot of material and will not hold as well and will not be as rigid (unless a whole mounting system is added, which adds many times the material needed for the basic ziptie version).
The model is 199.5mm long, which should fit on most standard sized printers. You can also print it diagonally on the printbed. Should you need/want a shorter version, you can just cut the model at every interface between two holder lugs (in the Slicer or after printing). There is also a shorter version (ca. 100mm) available, if you prefer that.
Printing
I printed mine with the following settings:
- 20% cubic infill
- 3 perimeters
- there is no need for support
- print it laying flat on its side