YAFS - Yet Another Filament Shelf
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Just a simple angle bracket for a easy filament shelf.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 255
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
I've been searching for a simple bracket/mount to replace my rather old filament shelf. While I liked quite a few of the designs available, I decided to do my own thing.
The hole in the brackets fits 22 mm wooden rods. To make it easier I also added the brackets without the hole so you simply create one that will fit your rod diameter. You can do this directly in any modern Slicer by adding a cylindrical negativemodifier in the right spot.
I've used 2 wooden rods with a length of 240 cm (approx. 95 inch). The recommended spacing of brackets would be 80 - 100 cm for a diameter of 22 mm. On the bottom there are holes for short screws to fix the rods in place. Predrill the screw holes and please handtighten the screws - otherwise you will split the layers! Adding these screws will give the whole shelf more sturdiness.
Recommended print settings:
- 4-5 walls
- 0.2 layer height
- 0.42 extrusion width
- 25% cubic or gyroid infill
- 3 bottom layers
- 4 top layers
Use whatever material you like the most. I used PLA (Prusament Galaxy Black).
Print time @250 mm/s for 1 bracket is approx. 90 minutes.
You can use the bracket either hanging or standing.