1 / 4
Apex Qi Charger Phone Stand APX-6813
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Made a charging phone dock for my Apex Qi charger. This charger is quite a bit larger than other Qi chargers.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 255
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Share Alike
Made a charging phone dock for my Apex Qi charger. This charger is quite a bit larger than other Qi chargers.
The dock has a tunnel for the micro-usb cable to go through.
Regarding infill: I printed the base at 8% to save time and material. I was worried that the arms will be fragile at 8%, so I changed them to 25%. Most slicers let you change slicing parameters at different heights - so up the infill at about 50mm height and upwards.
No supports or brim needed.