1 / 1
Pinda Adjustment pad (newer S Pinda, 1.5mm) — zdjęcie 1

Pinda Adjustment pad (newer S Pinda, 1.5mm)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

It helps you offset Pinda and nozzle far easier than paper and ziptie method. (newer S Pinda, 1.5mm)

Ocena
4,857 / 5
Polubienia
31
Pobrania
460
Wydruki
10
Wyświetlenia
1858
Oceny
14

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution

It helps you offset pinda and nozzle far easier than paper and ziptie method. 

Note: It is for newer S Pinda 1.5mm only. For 0.8 older version, you could open freecad file and decrease pad from 1.5mm to 0.8mm, then export stl file.

Steps:

1: Loosen and rise Pinda sensor.

2: You touch nozzle down on larger and lower area

3: Rise nozzle up a little so you can align high pad area to where pinda is, then lower nozzle down again.

4: Push Pinda into smaller and higher area on it.

5: Tighten Pinda

6: RE-SET LIVE Z, go to prusa3d discord for help if you are not sure how to adjust up and down.

Tagi