1 / 1
Pinda Adjustment pad (newer S Pinda, 1.5mm) — image 1

Pinda Adjustment pad (newer S Pinda, 1.5mm)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

It helps you offset Pinda and nozzle far easier than paper and ziptie method. (newer S Pinda, 1.5mm)

Rating
4.857 / 5
Likes
31
Downloads
460
Makes
10
Views
1,858
Reviews
14

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution

It helps you offset pinda and nozzle far easier than paper and ziptie method. 

Note: It is for newer S Pinda 1.5mm only. For 0.8 older version, you could open freecad file and decrease pad from 1.5mm to 0.8mm, then export stl file.

Steps:

1: Loosen and rise Pinda sensor.

2: You touch nozzle down on larger and lower area

3: Rise nozzle up a little so you can align high pad area to where pinda is, then lower nozzle down again.

4: Push Pinda into smaller and higher area on it.

5: Tighten Pinda

6: RE-SET LIVE Z, go to prusa3d discord for help if you are not sure how to adjust up and down.

Tags