1 / 4
Prusa XL Nozzle Scrubber Brush Holder for M3x10 Flathead Screws — zdjęcie 1
1 / 4

Prusa XL Nozzle Scrubber Brush Holder for M3x10 Flathead Screws

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Holder modified to accept M3x10 flathead mounting screws.

Ocena
5 / 5
Polubienia
13
Pobrania
74
Wydruki
3
Wyświetlenia
1081
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Printed with PETG filament, 0.4mm nozzle, 20% Grid Infill, 2 perimeters, 0.2mm layer height.

Requires qty two (2) M3x10 flathead screws, qty two (2)  3030 M3 T-slot nuts, qty one (1) brass bristle ¼ inch pen wire brush with 1/8 inch shank.

 https://www.amazon.ca/dp/B07TBFFC97?ref=ppx_yo2ov_dt_b_product_details&th=1

https://www.amazon.ca/dp/B09Z34W3NB?ref=ppx_yo2ov_dt_b_product_details&th=1

Update: January 25, 2024 - was cleaning the area with the vacuum cleaner when one of the brushes got sucked in and gone! I added provision for a 2.5mm or 3mm grub (set) screw less than 4mm long each to lock the brush in place. It might be an inconvenience to pull the brush out quickly to clean it, but better than losing it to the vac. You could try to snug up the grub screw to apply a little friction and still be able to pull it out without backing off the screws. I also made the hole insert for the brush closer to a standard 1/8" shaft, typical for a Dremel tool.

Tagi