Elegoo Neptune 2S side spool mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
90° side spool mount for the Neptune 2S, no supports needed
- Ocena
- 5 / 5
- Polubienia
- 15
- Pobrania
- 59
- Wydruki
- 1
- Wyświetlenia
- 524
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
BOM
A pair of M4 screws (length between 7 mm and 11 mm) and nuts (both hex and T will do). M3 screws and nuts may also do the trick if matched with a washer, but do it at your own risk.
Printing
Print the model in the given orientation and no supports will be needed.
Other settings are more of a personal taste, but keep in mind that this is a structural part, so I would choose tougher materials with higher heat resistance, specially if you print in an enclosure.
I personally picked ABS with 0.2 mm layer height and 40% gyroid infill.
A note on the filament path
Changing the angle to 90° gives more free-space, with the trade-off that the filament path may become awkward depending on your setup.
Since my printer is modded to direct drive with the BTT SFS V2 filament sensor mounted in the X stepper motor using this mount (designed by me), the filament path is fine.
A few words on compatibility
The original model was designed for the Neptune 2 but worked fine in my Neptune 2S and, judging by the comments, it also works with the Neptune 3.
Since this remix didn't change the extrusion mount neither the spool holder holes, the compatibility probably didn't change.