Ender-3 PSU Mount (Dual Z Offset)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
PSU side offset mount for Ender 3 with dual Z axis setup.
- Ocena
- 5 / 5
- Polubienia
- 6
- Pobrania
- 94
- Wydruki
- 1
- Wyświetlenia
- 624
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Quickly designed this basic mount because I wasn't finding anything that was simple and didn't require me to reroute the wires after upgrading to belt driven Z axis.
PSU is mounted at the extrusion's height allowing the XT60 connector to slip underneath or around it without any modification required.
I printed at 0.2mm and 100% infill. Mysterious Abyss PETG
The original M4 screws that came with the power supply were too short. I ended up using 2x M4-12mm screws with TPU washers (to reduce length and vibration). 2x M5-8mm and T-Nuts for the mounting to the 4040 extrusion.
I would recommend attaching a separate ground wire from the PSU to the printer's frame, just for extra safety.