Ender-3 PSU Mount (Dual Z Offset)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
PSU side offset mount for Ender 3 with dual Z axis setup.
- Rating
- 5 / 5
- Likes
- 6
- Downloads
- 94
- Makes
- 1
- Views
- 624
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Quickly designed this basic mount because I wasn't finding anything that was simple and didn't require me to reroute the wires after upgrading to belt driven Z axis.
PSU is mounted at the extrusion's height allowing the XT60 connector to slip underneath or around it without any modification required.
I printed at 0.2mm and 100% infill. Mysterious Abyss PETG
The original M4 screws that came with the power supply were too short. I ended up using 2x M4-12mm screws with TPU washers (to reduce length and vibration). 2x M5-8mm and T-Nuts for the mounting to the 4040 extrusion.
I would recommend attaching a separate ground wire from the PSU to the printer's frame, just for extra safety.