Ikea Enhet feet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These custom feet allow you to change the hight of your Ikea Enhet wall cabinet. Change the hight to fit your kitchen
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 43
- Wydruki
- 0
- Wyświetlenia
- 597
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
Sometimes Ikea can be the easiest solution for most simple problems, In our case this was kitchen storage.
In our kitchen we wanted to place an Enhet kabinet from Ikea, however due to the radiator placement this would not fit. To solve this issue I've cut the feet of the kabinet to size. After this the origional feed did no longer fit the cabinet, so it was time for some quick 3D design work.
I created this simple feed to solve this issue. This feed slides into the cabinet structure and after that the origional metal cover piece can slide over the 3D printed feed leaving only the button layer as an accent piece.
Installation:
Only works after you've cut the cabinet to size, otherwise you can just use the origional provided hardware. Slide the print into both sides of the Enhet structure, after that secure the Enhet to the wall.
Ready to customize for your own Enhet:
The original .FBX Fusion 360 file is included to allow you to change the hight of these 3D printed feed. This way you can make this part custom for your own (kitchen) setup!
Printed on the Da Vinci Nano using stock settings and XYZ Printing Tough PLA.