Meross MSG100 Smart GDO Mounting Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mounting bracket for Meross MSG100 Smart GDO
- Ocena
- 5 / 5
- Polubienia
- 6
- Pobrania
- 63
- Wydruki
- 1
- Wyświetlenia
- 351
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Mounting bracket for Meross MSG100/Refoss RSG100/Refoss MSG100 smart garage door opener (non-affiliate links).
The bracket is designed for Craftsman GDO, but should fit on any Chamberlain/LiftMaster or other GDO with mounting plate on the top of the unit, with a 2 mm thickness and 3 mm high opening (see images).
Instructions:
Additional parts: M3x10 bolt, M3 washer and M3 nut
The fit of the nut is tight, so it stays when the bracket is installed. If you pull the nut into the hole with a screw, make sure that the gap is supported with e.g. a flat screwdriver, so you don’t break the bracket while pulling the nut.
Install the bracket and then slide the Meross unit in it.
Print Settings
- Printer: Prusa i3 MK3S+
- Rafts: No
- Supports: No
- Support type: -
- Nozzle: 0.4 mm
- Resolution: 0.2 mm
- Infill: 15%
- Infill type: Gyroid
- Filament: PLA
Printed in: Spool3D Grey PLA