Govee H5198 4 probe meat thermometer box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A box for Govee H5198 4 probe wifi meat thermometer, this box holds the thermometer body, probes and wires
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 55
- Wydruki
- 0
- Wyświetlenia
- 279
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
The Govee H5198 thermometer works fine, but with 4 long probes and wires, it is not easy to put it away after I done using it. So I made this box to help hold the thermometer.
There is cutout on the side allowing access to the button and the USB C charging port, some space for 10x3mm round magnets, also some hooks to allow it to hang over thin lips
The compartment for holding thermometer is not super tight ( I don't want to scratch the thermometer too bad ), but it should somewhat hold it in place. I use vinyl tape to make it a snug fit and keep the printed surface from scratching the thermometer.
The probe storage likely will need a bit of clean up - the support tends to stuck in the narrow space, causing the probe difficult to be insert or remove. A 1/8 drill bit should clear it out nicely and the probe should slide in and out with little effort.
Print this standing up with the wire management holes facing downward should require the least support.