1 / 7
Back Cover for GameSir G8 (universal and Y700)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Back cover for the new G8 controller to hide the slider mechanism/springs.
- Ocena
- 5 / 5
- Polubienia
- 68
- Pobrania
- 1543
- Wydruki
- 2
- Wyświetlenia
- 13 954
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 2) (Komentarze: 15)Remiksy (2)Kolekcje (58)Powiązane
Created this cover to create a nice visual appearance on the back of the GameSir G8 Controller. Especially helpful if you cut the tabs to hyperextend the controller to fit a tablet (such as the Legion Y700 pictured). Recommend printing upright on end with a brim, no supports needed. You can go without brim if you are printing a shorter spacer/back cover.
3 Files included:
- 200mm universal - put your phone or tablet in your G8 and measure the gap at the back - then trim the file in your slicer to be about 1mm shorter than the gap (it needs to be slightly shorter so the springs can still clamp your device).
- 99mm Y700 - pre-sized to fit Y700.
- Y700 shim - due to the slimness of the tablet there is still a gap between the controller and tablet. Slide this in between so the controller feels more solid. I printed this with no top and bottom layers and honeycomb infill to keep it lighter.
Depending on how thick your phone/tablet is you may still want some sort of shim behind it.