IKEA Skadis holder for ruthex soldering tips for insets and some trays for small parts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
IKEA Skadis holder for ruthex soldering tips for insets and some trays for small things with hooks or for T-Nut system
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 75
- Wydruki
- 0
- Wyświetlenia
- 490
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
These are small holders for the ruthex soldering tips for heat insets. There are six versions:
- double row holder with hook
- double row holder with hook and text
- double row holder prepared for T-Nut
- double row holder prepared for T-Nut with text
- single row holder with hook
- single row holder with hook and text
For the T-Nut-system from 6d6178 (M3 screw) you need T-Nuts. They can be found at the T-Nut-System from 6d6178 or you use other T-Nuts like e.g. the ones i designed (T-Nuts).
As i also needed some trays for the insets i made some with hooks respectively with preparation for the T-Nut system. There are trays with 4, 6 or 8 compartments, the trays are 80mm wide. You may use the trays for other things like little screws.
Printing:
- PLA or PETG, any other material should work fine
- 3 Perimeters
- i used 15% infill
- for the hook versions i used a brim (only were the hook hits the bed), for the T-Nut version no supports are required
- Layer height: as you like, i used adaptive layer height in the slicer and it worked perfect