1 / 1
Filament Sensor to PTFE Tube Clamp for Kingroon KLP1 — zdjęcie 1

Filament Sensor to PTFE Tube Clamp for Kingroon KLP1

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Adapts the stock KLP1 filament sensor to a pneumatic fitting, so you can hand-feed filament easier.

Ocena
5 / 5
Polubienia
6
Pobrania
72
Wydruki
1
Wyświetlenia
569
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

Nothing much to say that wasn't in the summary, this just adapts the stock filament runout sensor on the KLP1 so you can screw in a standard pneumatic fitting.

That means you can feed filament in from the back of the printer without the PTFE tube getting pushed away from the sensor.

Note that the screw holes have 0.2mm thick center supports designed into the model, they should be breakaway once printing is done. Double-check in your slicer that they show up correctly, if they don't you might need auto-generated supports.

I've added a second model without those supports, if needed.

Versioning:
========

  • v1 : Initial commit
  • v2 : Cut off front corner for easier feeding, adjusted pneumatic fitting hole

Tagi