1 / 2
Snap-in motherboard feet (standoffs) for desktop use — zdjęcie 1
1 / 2

Snap-in motherboard feet (standoffs) for desktop use

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Orientacyjna cena wydruku pliku

0,25 € – 0,31 € netto (bez VAT)

Dla pliku: Motherboard foot snap-in.gcode

To wstępna wycena jednego pliku. Dokładną cenę poznasz przed zamówieniem.

Plik i założenia wyceny

Plik użyty do wyceny

Średnia wycena orientacyjna: 0,28 € netto (środek widełek).

Masa podana przez autora
1 g
Czas druku podany przez autora
24 min
Materiał u źródła
PLA
Materiał wyceny
PLA
Drukarka wyceny
Bambu Lab P1S - 0.4 nozzle
Proces wyceny
0.20mm Standard

Orientacyjna wycena wyłącznie wybranego pliku, oparta na masie i czasie druku podanych przez autora. Warianty plików nie są sumowane. Ostateczna cena zostanie obliczona po analizie pliku.

Zapisane na tym urządzeniu.

Plastic feet to make it safe and simple to use bare PC motherboards (ATX/mATX/mini-ITX) on your desktop.

Ocena
4,8 / 5
Polubienia
373
Pobrania
2062
Wydruki
11
Wyświetlenia
6432
Oceny
10

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution

Modified version with snap-in friction fit. No screws or threading required. 

The fit is a little bit tight to make sure that the feet doesn´t come lose by accident.

Update: The locking tabs were a bit too tight for modern motherboards that strictly adhere to the standards. 

If you have problems whith the tabs braking off when removing or inserting the feet, please try the “slim fit” version below. The diameter of the tabs is ~0,5mm smaller than the original ones and require the mounting holes to be Ø3,96mm/0.156" to remain in place if the motherboard is lifted up.

Tagi