HSW Mountable Case for ESP32 S2 Mini and LD2410C (Honeycomb Storage Wall)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A remix of my case for the ESP32 S2 Mini and LD2410C that is HSW mountable.
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 74
- Wydruki
- 0
- Wyświetlenia
- 1447
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial
Please comment, rate, and post a make!
A simple case for using an LD2410C radar sensors with an ESP32 S2 Mini that can be mounted to the HSW. I've included a little spacer that can be slid over the pins of the LD2410C to help with soldering to the ESP board. The lid has a cutout for the light sensor and the case body has holes for accessing the reset and programming mode buttons.
BOM (affiliate links):
- S2 Mini
- LD2410C
- USB Cable
- Something to mount them to the wall with:
- My preference is Gorilla Putty but a small Command strip should work just as well.
I'm using the this YAML configuration to integrate with Home Assistant.
- Slide the spacer over the pins on the LD2410C
- Solder the LD2410C to the ESP32.
- Trim the pins on the back of the ESP32 as flush to the board as possible.
- Slide the board into the case:
- Put the side with the radar in first. There's a lip on the inside of the case that the ESP board should sit on.
- Lower the rest of the board into place.
- Pop on the back cover.
Will require a blank insert to attach to the HSW.
Be sure to check out my other models!