HSW Mountable Case for ESP32 S2 Mini and LD2410C (Honeycomb Storage Wall)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A remix of my case for the ESP32 S2 Mini and LD2410C that is HSW mountable.
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 74
- Makes
- 0
- Views
- 1,453
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial
Please comment, rate, and post a make!
A simple case for using an LD2410C radar sensors with an ESP32 S2 Mini that can be mounted to the HSW. I've included a little spacer that can be slid over the pins of the LD2410C to help with soldering to the ESP board. The lid has a cutout for the light sensor and the case body has holes for accessing the reset and programming mode buttons.
BOM (affiliate links):
- S2 Mini
- LD2410C
- USB Cable
- Something to mount them to the wall with:
- My preference is Gorilla Putty but a small Command strip should work just as well.
I'm using the this YAML configuration to integrate with Home Assistant.
- Slide the spacer over the pins on the LD2410C
- Solder the LD2410C to the ESP32.
- Trim the pins on the back of the ESP32 as flush to the board as possible.
- Slide the board into the case:
- Put the side with the radar in first. There's a lip on the inside of the case that the ESP board should sit on.
- Lower the rest of the board into place.
- Pop on the back cover.
Will require a blank insert to attach to the HSW.
Be sure to check out my other models!