1 / 5
MicroSwiss NG 4020 fan shroud with Adafruit RBG LED added — zdjęcie 1
1 / 5

MicroSwiss NG 4020 fan shroud with Adafruit RBG LED added

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Added an LED to the shroud and in KLIPPER, used the Voron RBG macro to run.

Ocena
0 / 5
Polubienia
7
Pobrania
59
Wydruki
0
Wyświetlenia
597
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Share Alike

I ran 3, 24 awg wires, from the RGB through the housing and added a piece of heat tube where the wire is exposed on the outside.  I ran it outside because I am not great at Fusion 360 and didn't know how to mod the file any other way at the time.  If someone is better and interested in doing this correctly then please share with everyone.  If you just want to use this, it does work but I had to superglue the LED in place because the wire and clips just wouldn't fit properly.  I didn't want to reprint so ended up having to remove one side of the LED supports to get it in.  It has been running for over 6 months now and have not had any issues so I'm happy with it.   I also attached a file for an accelerometer attached to the face of the Original Micro Swiss NG Extruder Shroud for 4020 blower fan by IXI3DBE on Thingiverse: https://www.thingiverse.com/thing:5393935 .  

Tagi