Extrusion multiplier Blocks v2 for Ellis' Tuning Guide (flow tuning)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
better to print
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 99
- Wydruki
- 0
- Wyświetlenia
- 461
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Here we have version 2. This time the numbering is on the bottom
These blocks are perfect for setting the optimal extrusion if you follow the instructions from Ellis Tuning Guide ← Here it is also explained how you have to set up your slicer
the best way to achieve the optimal result (assuming your extruder is properly calibrated)
First print the set 80 - 110 so you have the first rough overview
Now as an example you look at the blocks and see 0.95 looks good, 1.00 is a bit too much
then the next step would be to print the set 0.96 - 0.99
and look which block is the best then you would have the result to within 1%
If your results are below 0.80 or above 1.10, you should definitely calibrate your extruder again