1 / 4
BTT SFS V2.0 (Filament Sensor) Mount for V-Core 3.1 or 3030 Extrusions — zdjęcie 1
1 / 4

BTT SFS V2.0 (Filament Sensor) Mount for V-Core 3.1 or 3030 Extrusions

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Mount for the BTT SFS V2.0 Filament Sensor, compatible with 3030 Extrusions and made for the new RatRig Toolhead

Ocena
0 / 5
Polubienia
10
Pobrania
105
Wydruki
0
Wyświetlenia
633
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

Since the new Toolhead from RatRig goes over the back extrusion, routing the reverse bowden tube down the middle is not possible anymore. So I made a quick mount for my BTT SFS V2 Filament sensor to mount to the side.
This way the PTFE Tube comes up in the corner and clears both the Toolhead as well as the X-gantry joiners at the furthest possible position.

Needs 2 M6 caphead screws and T-nuts, but 1 is probably enough. (3x M3 caphead screws are included with the BTT SFS V2)

printed with 0.2mm layer height and without supports in ABS+

Tagi