Unifi U6+ spacer bracket for DIY outdoor enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Budget yet fully operative outdoor weatherproof and vented enclosure for Unifi U6+
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 294
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
I had to install a spare Unifi U6+ wifi access point outdoor to connect to various appliances (EV car charger, EV Car, Shelly EM that monitors wind turbine, etc…)
U6+ is rated IP 54, then only dust protected + resistant to 10 minutes of splashing water ; not enough for a device that will be exposed to rainy days.
I got inspired by this perfect but very expensive enclosure : https://altelix.com/altelix-vented-weatherproof-enclosure-for-ubiquiti-unifi-u6-enterprise-access-point ; so I customized an IP65 outdoor electrical junction box that does a perfect job.
Your shopping list if you want to do it :
- 1 * 263 x 185 x 95 mm IP65 electrical junction box, 23 € at Amazon France : https://www.amazon.co.uk/Electrical-Junction-Electronics-Water-resistant-Enclosure/dp/B09H622LN3
- 1 set of 19 mm cut-out industrial airing grille ( only sold in 2 units pack ), 4 € at any electrical supplies store : https://www.se.com/uk/en/product/NSYCAG19LP/airing-grille-cutout-diameter-19mm-ip45/
- 5 * 20x4 mm countersunk wood/plastic screw
The box from Amazon is suprisingly good quality for its price,
Then proceed as follows :
- print the spacer bracket, I enclosed a 3MF if you want to use my settings (generic PLA, 0.2 quality, no first layer) and even F3D if you want to modify it
- using a step drill bit, drill a 19 mm hole on each upper part of the sides to attach the airing grilles
- attach the printed spacer bracket to the box with 3* countersunk screw
- attach the U6+ base to the bracket using 2* countersunk screws
- using a step drill bit, make a hole in the box under the bracket to let the ethernet cable in
- attach your box to the outside wall, seal the ethernet cable hole with silicone cartridge
- install U6+, mine is PoE
- close the box, don't forget to push the sealing cord into the cover grove
- et voilà !