Unifi U6+ spacer bracket for DIY outdoor enclosure
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Budget yet fully operative outdoor weatherproof and vented enclosure for Unifi U6+
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 18
- Makes
- 0
- Views
- 297
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
I had to install a spare Unifi U6+ wifi access point outdoor to connect to various appliances (EV car charger, EV Car, Shelly EM that monitors wind turbine, etc…)
U6+ is rated IP 54, then only dust protected + resistant to 10 minutes of splashing water ; not enough for a device that will be exposed to rainy days.
I got inspired by this perfect but very expensive enclosure : https://altelix.com/altelix-vented-weatherproof-enclosure-for-ubiquiti-unifi-u6-enterprise-access-point ; so I customized an IP65 outdoor electrical junction box that does a perfect job.
Your shopping list if you want to do it :
- 1 * 263 x 185 x 95 mm IP65 electrical junction box, 23 € at Amazon France : https://www.amazon.co.uk/Electrical-Junction-Electronics-Water-resistant-Enclosure/dp/B09H622LN3
- 1 set of 19 mm cut-out industrial airing grille ( only sold in 2 units pack ), 4 € at any electrical supplies store : https://www.se.com/uk/en/product/NSYCAG19LP/airing-grille-cutout-diameter-19mm-ip45/
- 5 * 20x4 mm countersunk wood/plastic screw
The box from Amazon is suprisingly good quality for its price,
Then proceed as follows :
- print the spacer bracket, I enclosed a 3MF if you want to use my settings (generic PLA, 0.2 quality, no first layer) and even F3D if you want to modify it
- using a step drill bit, drill a 19 mm hole on each upper part of the sides to attach the airing grilles
- attach the printed spacer bracket to the box with 3* countersunk screw
- attach the U6+ base to the bracket using 2* countersunk screws
- using a step drill bit, make a hole in the box under the bracket to let the ethernet cable in
- attach your box to the outside wall, seal the ethernet cable hole with silicone cartridge
- install U6+, mine is PoE
- close the box, don't forget to push the sealing cord into the cover grove
- et voilà !