Switch for hand warmer (ihatethecold.com)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a replacement switch for the pictured hand warmer from "ihatethecold.com". The original fell off and got lost.…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 151
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a replacement switch for the pictured hand warmer from "ihatethecold.com". The original fell off and got lost. This one will need to be attached with a small amount of glue. Be careful to only use a small amount and only where you need it. I used a "gel" type super glue. You could also probably use a small amount of two part epoxy.
Print Settings
Printer Brand:
Anycubic
Printer:
All-metal Mega
Rafts:
Doesn't Matter
Supports:
Doesn't Matter
Resolution:
0.1
Infill:
Doesn't Matter
Filament:
CC3D PETG Black
Notes:
I recommend printing this in a heat resistant material.... because it's a hand warmer. I used PETG. I'm sure ABS would also work.
If this design was useful to you, please post a make!